product-1

Talas Dryer

Talas Dryer monitors winding insulation resistance and keeps the insulation dry at all times.

Talas Dryer Datasheet ENG

product-2

Main facts

  • Measures the winding insulation resistance when motor is de-energized
  • In case of low winding insulation resistance drying mode switches on
  • Can recover the winding insulation of flooded electric motors
  • Has a standby heating mode making smart and energy efficient alternative to energy consuming heating cable and space heaters
  • Operational and measurement data can be extracted to all common automation systems
  • Operates fully automatically
  • Can be installed to existing and new electric motors
  • Does not require any maintenance
  • Installed close to MCC
  • Extremely cost effective way to monitor and dry winding insulation without any additional work

How it works

Simple and reliable

product-3

When electric motor switches off Talas Dryer waits for 30 minutes and then connects to the two phases of the main feed cable. It measures the insulation resistance by feeding direct current voltage to the circuit and then monitors the leakage current from the ground. When the insulation resistance is low Talas Dryer switches on the drying mode and starts to send direct current impulses to the windings of the electric motor. During the drying mode Talas Dryer also monitors the winding insulation and when the insulation

resistance has reached a satisfactory value the drying mode switches off and the measurement mode continues. When the motor receives a start command Talas Dryer disconnects from the main feed cable and goes to standby mode. Talas Dryer can be also used as an intellectual standby heater. In the standby heating mode lower current is used and the direct current feeding switches on regardless of the insulation resistance value. Insulation resistance is also monitored during the standby heating mode.

product-4

As stated in the book ”Electrical Insulation for Rotating Machines (2014)” about the usefulness of the insulation resistance test:

“In general, the IR/PI test is an excellent means of finding windings that are contaminated or soaked with moisture. Of course, the test is also good at detecting major flaws where the insulation is cracked or has been cut through”

and about the procedures if the winding temperature has been below the dew point and the insulation resistance test results are poor:

“It will probably be necessary to heat the winding by circulating hot air or passing current through the winding for hours or days to dry off the moisture that has condensed on it”

Would you like to make both of these procedures fully automatic?

2form
factors

Talas Dryer can be supplied in two different forms for different installation conditions

product-5

Single Device

The classic installation, one Talas Dryer for one electric motor. Good option when there are only one or two motors in harsh conditions or MCCs are located in different places.

Cabinet Installation

Good and cost effective choice if there are several electric motors operating in harsh conditions and their MCCs are located close to each other.

product-demo

When several MCCs are located close to each other Talas Dryer cabinet can be “mounted” into your electric room as any other control or protection unit.

Talas Monitoring